Wanted Cheap Bulk Inkjet Inks

[Kuurgen]

Looking for continious ink refills for Epson.

Or just bulk inkjet inks covering the light magenta magenta light cyan etc.

[bug]

http://www.thesourcecc.com/estore/Product.aspx?language=en-CA&catalog=Online&category=InkRefills_Epson&product=2618857
COMPATIBILITY: Epson R200/R300/R320/Rx500/Rx600/Rx620

[I0s]

i have ordered refill kits from these guys, not bad.
pretty decent prices too.
http://www.re-inks.com/epson.asp

[Kuurgen]

Hi,

Thanks very much!


I have the continuious ink system foir my R200, I'm looking for one for my r220
as well!

I wish the source carried it, it's make my life so much easier!

The math on the refills doesn't work out, at 10 bucks a colour i can just rebuy the ink system again for refills and get 70 ml instead of the 30ml the ink refills offer from the source.

[smoothsailor]

Has anyone come across a continuous ink supply system for HP Printers and Plotters ?

[FastFokker]

http://www.thesourcecc.com/estore/Product.aspx?language=en-CA&catalog=Online&category=InkRefills_Epson&product=2618857
COMPATIBILITY: Epson R200/R300/R320/Rx500/Rx600/Rx620Nice one!

Anybody have any comments on this setup? I have an R200 and was just about to get my cartridges refilled by Island Inkjet, but it was going to cost $13/black and $10/each colour.. frig that's expensive!

This looks like a much better value, is the quality good?

[Kuurgen]

Quality is excellent on the CIS systems.

Go ahead and get it, be sure to do the waste ink mod to your printer while your at it.

[Umbearto]

I got this system for my R200 a couple months ago. All seemed well, but I began to notice the large outer tanks seemed to be going down pretty fast. I had installed the system in a virgin printer that had never seen Epson Carts, and had installed the Waste-Ink Tank mod, and I'm glad I did. The other day, I noticed the Light Magenta tank was near empty. Apparently, it had just siphoned straight through the printer and into the waste-ink bottle.

It might just be the high altitude here that made this occur, but I would strongly suggest you do the waste-ink mod before installing this system.

I could probably have solved this by having the exterior tanks a little bit lower than the printer, and through trial and error have found the correct placement (clearly, having them level with the printer up here in Calgary led to a slow, continuous flow), but I didn't have time and took the system out.

I think I'll try swapping the exterior tanks for the 2-Stage tanks from an old JLWSales kit I have lying around and see if that can keep an equal pressure and stop the siphon effect.

Keep an eye on your exterior tank levels; mark them with a piece of tape, or something. If you notice them dropping suspiciously fast, or like me, have a tank drain out, try lowering the tank level to slightly below the printer.

I really like the system, and the price-point is very good, just beware of the siphon effect.